Setting A Middle Position; Deleting The Middle Position - FAAC TM2 ERX Manual De Instrucciones

SETTING A MIDDLE POSITION

This function allows the rolling shutter to be set at a favourite middle position. When
this middle position is memorized, you just press the stop button for 2 seconds and
automatically the motor will move the shutter to this position.
To memorize the middle position, move the rolling shutter to the desired position
and then hold the STOP button down (for about 2 sec) until the motor gives con-
firmation.
Tn: Already programmed remote control

DELETING THE MIDDLE POSITION

If you want to delete the middle position, it can be done as described below.
To change this position, it's also necessary to delete first the memorized middle
position. Before deleting it's necessary to drive the motor to the middle position
(by pressing button B for 2 seconds), then press again button B (stop) for about 4
seconds until the motor confirms the operation by a longer movement.
Tn: Already programmed remote control
B
Tn (2 sec)
TM2 ERX
B
Tn (4 sec)
B
Tn (4 sec)
33 A4518_6G41_Rev.A