Adding Tags; Maintenance - FAAC XTR B Manual De Instrucciones

9. ADDING TAGS

You must have a Master Tag that has already been
stored and be close to the XTR B (without having
to open it).
If the XTR B is connected to a BUS-RELAY
interface, use a Master Tag of the required
Group.
The XTR B must be in standby.
1. Bring a Tag that has NOT been stored up to the
reader and wait for about 5 s:
- The XTR B will BEEP twice and FLASH twice, then
the LEDs will come on steadily.
2. Move the Tag away.
3. Bring the previously stored Master Tag up to the
reader within 10 s.
- The LEDs still remain steady, the XTR B will
BEEP once.
4. Choose whether to add Master or Slave tags:
move the Master Tag
away within 5 s: MASTER
tags will be added.
- It will flash for 10 s (storing enabled).
5. Bring the Tags to add up to the reader in se-
quence, within 10 s of each other. The XTR B
will BEEP once and the LEDs turn on for 1 s for
each Tag added.
6. To finish, let 10 s pass without bringing a new
Tag up to the reader.
- The LEDs turn off: XTR B in standby.

10. MAINTENANCE

Clean the outer surfaces only with a soft cloth Do not
use detergents or oils.
XTR B
wait until the XTR B
BEEPS twice, then move
the Master tag away:
SLAVE tags will be added.
1
2 ( ) ,
2
... 10 s ( timeout)
3
1 
4
- MASTER
 < 5 s
10 s ( timeout)
... 10 s MAX
5
1  +
1 s: Tag OK ,
 timeout without Tag:
6
13
ADDING TAGS
 ~ 5 s
Tag NOT stored
Master Tag already stored
4
- SLAVE
 > 5 s
2 
Tag to add
10 s  timeout
END
532109 - Rev.A