Felisatti AS20 Instrucciones De Servicio página 7

1.2 Warning
▶ Persons (including children) who are, due to
their physical, sensory or intellectual abilities
or lack of experience or knowledge, unable
to safely use the vacuum device should not
use it without supervision or instruction by a
responsible person.
▶ Particular caution is advised with children,
elderly or infirm persons.
▶ Do not point nozzle, tube or hose at people
or animals
▶ Use only the brushes supplied with the
vacuum device or defined in the instruction
manual. Use of any other brushes may pose
a safety hazard.
▶ Clean and disinfect the vacuum device
immediately after use to prevent microbial
contamination due to long-term failure to
clean it, especially when using the device in
food-processing.
▶ Do not use any steam jets or high-pressure
cleaners for cleaning.
▶ Acids, acetone and solvents may corrode
parts of the vacuum device.
▶ Do not leave the device without supervision.
In case of longer interruptions of work, pull
the power plug.
▶ Do not clean filter cassettes with com-
pressed ai
▶ Acids, alkalis and solvents can corrode the
vacuum cleaner parts.
▷ Clean the container and accessories with
water.
▷ Wipe the top section with a damp cloth.
▷ Allow the container and accessories to dry
2 Before use
▶ When unpacking, check that the delivery is complete and that
there is no transport damage.
▶ Before using, the operators should be provided with informa-
tion, instructions and training for the use of the vacuum
cleaner and the substances that it is to be used for, including
the safe procedure for the removal of the gathered material.
3 Only use original accessories
Further accessories are given in the special acessories list or
upon request.
Original operatin instructions in German
4 Fields of application
For wet and dry suction cleaning. Not suitable for vacuuming
health hazardous dusts. The suction cleaner with socket and ON/
OFF automatic switching system is intended for the connection
of electric tools.
5 Assembly
When unpacking, check that the appliance is complete and that
there is no transport damage.
5.1 Equipment
- 1 x Suction hose (3.2 m long)
- 1 x plastic tube handle with supplementary air slide
- 2 x plastic suction tube (each 48 cm long)
- 1 x universal nozzle
- 1 x crevice nozzle (21 cm long)
- 1 х paper bag
- Operating instructions with Safety instructions
- Warranty
5.2 Container ⑫
Open the lock-in closures ⑭ of the container, and lift off the top
section ①. Tip over the container and press in the steering rollers
with pivot ⑰ until they lock into place. Screw the large wheels ⑮
onto the axles ⑯; see fig. A.
Insert suction tube AS20/1200 ⑳ (when contained in scope of
supply) into the container guide from above and push down until
it engages.
5.3 Filters ⑧ - ⑪
Fitting the filters, depending upon the given model:
- Push the folded filter cartridge ⑩ in a straight manner over
the case ⑤, right up to the stop point, and lock the bayonet
mount ⑪; see fig. D. The folded filter is suitable for wet and
dry suction cleaning.
- Foam filter
To suction the water, first remove the folded filter; push the
foam filter ⑧ over the casing ⑤, see Fig. E
- Take hold of the paper filter bag ⑱ at the flang and push verti-
cally from above into the guide of the cyclone suction opening
⑬ until the stop point is reached. The bag must rest against
the container wall; see fig. F.
For stainless steel containers, push the flange onto the suc-
tion opening at the bottom first and then at the top, then keep
pushing as far as it will go.
- The bag increases the dust retaining capacity and is intended
for hygienic disposal. Paper filter bags can only be used for
dry suction cleaning.
- Place the filter sack ⑨ in the container ⑫ respectively for
stainless steel containers slip over the edge of the container,
see fig. G.
Remove the filter for wet suction cleaning.
7