Jacuzzi morphosis MEGA Uso Y Mantenimiento página 28

Date
The display shows the format "day/month/year".
Setting the date
I Check that the date is shown with a blue light, if necessary
press the "calendar" key. Then press the same key for about
two seconds. On the display, the two numerals that represent
the day will start to flash, and the keys(+) and (—) will turn
blue.
If you do not make a selection within 10 seconds, you will exit set-
ting mode.
I Adjust the day using the keys (+) and (—). Each press cor-
responds to an increase/decrease of 1 day. Press and hold
the key for continuous change.
I Once you have obtained the desired value, press and re-
lease the "calendar" key. The day will be memorized and you
will automatically proceed to setting of the month (the corre-
sponding numerals will flash).
I Set and memorize the month in the same manner as for
setting the day.
I Once you have obtained the desired value, press and re-
lease the "calendar" key again. The month will be memorized
and you will automatically proceed to setting of the year (the
corresponding numerals will flash).
Now press key (1) again to memorize the year and exit setting
mode.
NOTES
- Before using the electronic functions and making the described
adjustments, make sure that the system is active (time shown
with blue light, refer to the chapter on preliminary operations).
- The time and date settings are stored in memory even when
the box is off for about 5 months. After that time, you will need
to reset the values as described above.
- The default values ("00.00" for the time and "01.01.07" for
the date) will be kept until a first setting is made.
- The display always shows the time, except for when the alarm
and/or the drain phase of the anti-scale cycle are active.
During the Turkish bath, you can view the time or date by press-
ing the corresponding key.
In any case, when these functions are active, it is not possible
to adjust the time and date.
28