Technical Characteristics - Cepex EXTREME Serie Manual De Instalación Y Mantenimiento

2.2 Valve components
Fig. 2
3
5
10
3. BALL VALVE
3.1 VERICATION OF VALVE TYPE
On opening the packaging please check that the valve is the model ordered.
Check that the actuator model corresponds with the code number ordered. Make especially sure that the voltage indicated on the
actuator label corresponds to that of your mains supply (actuators do no incorporate valves, meaning that incorrect voltage will cause
irreparable damage to the device).
All valves are electrically and hydraulically tested in the factory. Valves will always be replaced in the event of any justifiable claim.
For more technical information about the actuators, please refer to the instruction manuals attached to the valve documentation.
3.2 GUARANTEE
This equipment has been extensively tested in the factory, thus guaranteeing it is in perfect working condition. This guarantee will be
applicable assuming the device has been properly installed and not used in an incorrectly. For this reason, this equipment must be
installed by a suitably qualified person.

3.3 TECHNICAL CHARACTERISTICS

Pressure / Temperature Chart. (G 3.1)
psi bar
0 10 20 30
32 50 68 86
DN65 - DN100 (PVC-U, CPVC) (G 3.2)
psi bar
0 10 20 30
6
32 50 68 86
[IND] ELECTRIC BALL VALVE
7
9
2
6
8
PVC-U
PVC-C
PP-H
40 50 60 70 80 90 100
104 122 140 158 176 194 212
PVC-U
PVC-C
40 50 60 70 80 90
104 122 140 158 176 194
4
10
1
Pressure loss chart (G 3.3)
ºC
ºF
ºC
100
ºF
212
FIG. Parts
1 Shaft
2 Ball
3 Union nut
4 Handle
5 End connector
6 Dampener seal
7 Shaft o-ring
8
Body o-ring
9 Ball seat
10 End connector
11 Body
12 Seal-carrier
3
5
Flow / Débit / Caudal / Portata / Durchfluss / Caudal
ENGLISH
Material
PVC-U / CPVC / PP-H
PVC-U / CPVC / PP-H
PVC-U / CPVC / PP-H
PP-GR + TPE
PVC-U / CPVC / PP-H
EPDM perox. / FPM
EPDM perox. / FPM
EPDM perox. / FPM
PTFE
EPDM perox. / FPM
PVC-U / CPVC / PP-H
PVC-U / CPVC / PP-H
ºC
ºF