Mode) Button; Information Mode; Demonstration Mode - SOMFY Sunis indoor WireFree RTS Guia De Instalacion

Installation guide

5.5. (Mode) button

Briefly press the (Mode) button to activate information mode.
Press and hold the (Mode) button to activate demonstration mode.

5.5.1. Information mode

- Briefly press the (Mode) button to find out the status of the sensor.
If the LED (red/green) flashes: the sensor is in demonstration mode.
If the LED (red/green) is permanently lit: the sensor is in operating mode.
If the LED is red: the level of sunlight intensity is lower than the set
sunlight threshold.
If the LED is green: the level of sunlight intensity is greater than the
set sunlight threshold.

5.5.2. Demonstration mode

The very short response times in demonstration mode make it
possible to check the installation.
Do not change the sunlight threshold setting in demonstration
mode.
The same procedure is used to activate or deactivate
demonstration mode.
- Press and hold (>2 sec.) the (Mode) button to
activate or deactivate demonstration mode.
If the red/green LED flashes for a few
seconds (30 sec.) then demonstration mode
is activated.
8
Sunis indoor WireFree™ RTS
Copyright © 2010 Somfy SAS. All rights reserved.
> 2 s