Quick GP2 GENIUS Serie Manual De Instalacion Y Uso página 15

BEFORE USING THE WINDLASS READ THESE INSTRUCTIONS CAREFULLY.
IF IN DOUBT, CONTACT YOUR NEAREST "QUICK
WARNING • The Quick
• Quick shall not be held responsible for damage to equipment and/or personal injury, caused by a faulty use of the
®
equipment. • The windlass is not designed for the loads that might occur in extreme weather conditions (storms)
• Always deactivate the windlass when not in use. • Check that there are no swimmers nearby before dropping anchor.
• The splice between the rope and the chain must be tightly woven for the rope to slide easily into the gypsy shape. For any
problem or request, feel free to contact Quick
• For improved safety we recommend installing at least two anchor windlass controls in case one is accidentally damaged.
• We recommend the use of the Quick
• Secure the chain with a further device before starting the navigation.
• The contactor unit or reversing contactor unit must be installed in a point protected from accidental water contact.
• After completing the anchorage, secure the chain or rope to fixed points such as chain stopper or bollard.
• To prevent accidental releases, the anchor must be secured. The windlass shall not be used as the only securing device.
• Isolate the windlass from the power system during navigation (switch the circuit breaker off) and lock the chain securing it to a
fixed point of the boat.
THE PACKAGE CONTAINS: windlass - reversing contactor unit - base gasket - drill template - handle - bolts and screws (for
assembly) - user's manual - conditions of warranty.
TOOLS REQUIRED FOR INSTALLATION: drill and drill bits: Ø 9 mm (23/64") and Ø 11 mm (7/16") - Ø 40 (1" 9/16) hollow mill;
hexagonal wrenche: 13 mm.
"QUICK "ACCESSORIES RECOMMENDED: anchoring RL control board (mod. 800 - mod.810WCS) - Waterproof hand helds
®
R/C (mod. HRC 1002) - Foot switch (mod. 900) - Hydraulic-magnetic circuit breaker - Anchor chain counter (mod. CHC 1102M and
CHC1203) - Radio control RRC (mod. R02, P02, H02).
INSTALLATION REQUIREMENTS: the windlass must be positioned with the gypsy aligned with the bow roller. Ensure that
the upper and lower surfaces of the deck are as parallel as possible. If this is not the case, compensate the difference appropri-
ately (a lack of parallelism could result in a loss of motor power). The deck thickness must be included among the figures listed
in the table. In cases of other thicknesses it is necessary to consult a Quick
the passage of cables, rope and chain; lack of depth of the peak could cause jamming.
FITTING PROCEDURE: when the ideal position has been established, drill four holes using the drilling template provided.
Remove excess material from the chain through hole, ensuring the free passage of the chain or rope. Position the windlass low-
ering it from above deck and inserting the gasket between the deck and the base. Screw the stud bolts, using the short threaded end, onto the base. Apply a medium grade locking product onto the thread. Fix the windlass by screwing the nuts onto the fixing
studs. Connect the supply cables from the windlass to the reversing contactor unit.
WARNING: before wiring up, be sure the electrical cables are not live.
GP2 SERIES GENIUS 1500/2000 - REV001B
" DEALER.
®
windlasses are designed to weigh the anchor • Do not use the equipment for other purposes.
®
Technical Service.
®
hydraulic-magnetic switch as the motor safety switch.
®
MAX 5 mm
(3/16")
45°
INSTALLATION
retailer. There must be no obstacles under deck to
®
40 cm
(16")
EN
15