1. PREPARE THE HOOD LOCATION AND SELECT THE INSTALLATION TYPE
This exhaust hood is designed for use with gas or electric outdoor cooking appliances when operated in an outdoor covered
patio or lanai area. As with all electric appliances, this unit should be protected from the effects of weather as much as possible.
This unit is not designed for use with a charcoal grill.
Either an interior or exterior blower or in-line blower may be used with this hood. The Best by Broan WPD29M Series must be
installed with blower models P12D, ILB11, EB12 or EB15 only. Other blowers cannot be substituted. (Blowers sold separately.)
Plan where and how the ductwork will be installed.
If installing ILB11 in-line blower, discard its rough-in plate. Refer to instructions packed with in-line blower and follow
steps 1 up to 6, 8, 9, 10, 11, 13 and up of this manual.
Install 10" round galvanized steel ductwork, elbows and roof or wall cap for the type of blower you are installing. Use metal duct
tape to seal duct joints.
The minimum hood distance above cooktop must not be less than 30''. A maximum of 36" above cooktop is highly
recommended for best capture of cooking impurities.
Distances over 36" are at the installer and users discretion.
Run power cable to installation location.
The power cable must be a GFCI protected branch circuit.
ROOF CAP
10" ROUND DUCT
OPTIONAL DECORATIVE
FLUE or SOFFIT
10" ROUND ELBOW
HOOD
17 11/16" to
18"
TOP OF WOOD
MOUNTING STRIP
30" TO 36" ABOVE
COOKING SURFACE
HH0073A
MODEL P12D DUAL INTERIOR
BLOWER TYPICAL DUCTWORK
!
!
10" ROUND DUCT
WALL CAP
OPTIONAL DECORATIVE
FLUE or SOFFIT
10" ROUND ELBOW
9" x 18" to 10"
ROUND
TRANSITION
18"
INCLUDED
30" TO 36" ABOVE
COOKING SURFACE
HH0074A
MODEL EB12 OR EB15 EXTERIOR
BLOWER TYPICAL DUCTWORK
WARNING
WARNING
EXTERIOR
BLOWER
9" x 18" to 10"
ROUND
HOOD
17 11/16" to
TRANSITION
TOP OF WOOD
INCLUDED
MOUNTING STRIP
- 4 -
ROOF CAP
10" ROUND DUCT
IN-LINE BLOWER
HOOD
30" TO 36" ABOVE
COOKING SURFACE
HH0075A
MODEL ILB11 IN-LINE BLOWER
TYPICAL DUCTWORK
WALL
CAP