Nice MOTB Instrucciones Y Advertencias página 6

Example: the combination "5678" is valid both for the " " key and for " ".
4.1.1 - Procedure to block and release the automation
With this function it is possible to use the keyboard to send the automation
"block" or "release" command. Note – If both procedures have been performed
correctly, the keyboard emits 3 acoustic tones (beeps) and the keyboard lighting
indicates the functioning status (see chapter 5 Table 5).
• Procedure to block the automation
01. Press the key: the keyboard enters the error status and emits the "error"
signal for incorrect combinations
02. Enter "00" within 10 seconds
03. Enter a valid combination within 10 seconds
04. Press the key to confirm
• Procedure to release the automation
01. Press the key: the keyboard enters the error status and emits the "error"
signal for incorrect combinations
02. Enter "11" within 10 seconds
03. Enter a valid combination within 10 seconds
04. Press the key to confirm
4.2 - Programming procedure in EASY mode
In EASY mode it is possible to enter 2 combinations, one valid for the " " com-
mand and one for the " " command. Or a unique combination for both com-
mands. A minimum of 1 to a maximum of 9 characters can be used for the
combinations. The keyboard emits acoustic tones when the numbers are
entered. Below find the description of the programming procedures for just one
command or for both commands. Note – The keyboard emits 3 acoustic tones
at the end of any procedure providing that it has been carried out correctly.
Recommendation – At the end of programming it is necessary to check cor-
rect functioning of the MOTB; see chapter 5 - Inspection.
4.2.1 - Procedure for programming a combination
Procedure for the " " command
With this procedure it is possible to enter a second combination for the other
4 – English
command at any time.
01. Press the "P" key (fig. 3)
02. Within 30 sec. insert the combination by entering the numbers on the keyboard
03. Press the key twice
Procedure for the " " command
With this procedure it is possible to enter a second combination for the other
command at any time.
01. Press the "P" (fig. 3)
02. Within 30 sec. insert the combination by entering the numbers on the keyboard
03. Press the key twice
Procedure for the " " and " " commands
01. Press the "P" key (fig. 3)
02. Within 30 sec. insert the combination by entering the numbers on the keyboard
03. Press the key once and the
The commands associated to the " " and " " keys are factory-set as:
" " = Step-by-Step.
" " = Partial open.
It is also possible to:
– Change the type of command associated to a combination (see chapter 6.1)
– Block and release the automation (see chapter 4.1.1)
– Delete the data in the BM memory (see chapter 6.2).
4.3 - Programming procedure in PROFESSIONAL mode
In PROFESSIONAL mode all functions can be managed directly on the keyboard;
several combinations can be entered as well as other specific functions. A mini-
mum of 1 to a maximum of 9 characters can be used for the combinations. Every
time a character is entered using the keyboard an acoustic tone is emitted.
A "programming password" must be entered in order to access the program-
ming functions. This is composed of 7 characters and can be modified (see
paragraph 4.3.2). This factory password is 0333333.
This password is indispensable for all programming phases; therefore do
not forget it, otherwise the memory must be deleted.
Below find the description of the programming procedures for just one com-
key once