Accessories; Assistance Or Service - Whirlpool W10266784A Manual Del Usuario

Is the water pressure at least 30 psi (207 kPa)? The water
n
pressure to the home determines the flow from the dispenser.
See "Water Supply Requirements."
Kink in the home water source line? Straighten the water
n
source line.
New installation? Flush and fill the water system.
n
Water filter installed on the refrigerator? The filter may be
n
clogged or incorrectly installed.
Is a reverse osmosis water filtration system connected to
n
your cold water supply? See "Water Supply Requirements."
Water is leaking from the dispenser
NOTE: One or two drops of water after dispensing is normal.
Glass not being held under the dispenser long enough?
n
Hold the glass under the dispenser for 2 to 3 seconds after
releasing the dispenser lever/pad.
To order accessories, contact the dealer from whom you
purchased your refrigerator and ask for the appropriate part
number listed below.
Stainless Steel Cleaner and Polish:
Part #4396095
Before calling for assistance or service, please check
"Troubleshooting." It may save you the cost of a service call. If you
still need help, follow the instructions below.
Contact the dealer from whom you purchased the refrigerator.
If you need replacement parts
To locate factory specified replacement parts in your area, contact
the dealer from whom you purchased your refrigerator.
Warranty
Contact the dealer from whom you purchased the refrigerator for
warranty information.
Keep this book and your sales slip together for future
reference. You must provide proof of purchase or installation
date for in-warranty service.
W10266784A
© 2009.
All rights reserved.

ACCESSORIES

ASSISTANCE OR SERVICE

New installation? Flush the water system. See "Prepare the
n
Water System" or "Water and Ice Dispensers."
Recently changed water filter? Flush the water system. See
n
"Prepare the Water System" or "Water and Ice Dispensers."
The dispenser water is not cool enough
(on some models)
NOTE: Water from the dispenser is chilled to only 50°F (10°C).
New installation? Allow 24 hours after installation for the
n
water supply to cool completely.
Recently dispensed large amount of water? Allow 24 hours
n
for water supply to cool completely.
Water not been recently dispensed? The first glass of water
n
may not be cool. Discard the first glass of water.
Refrigerator connected to a cold water pipe? Make sure
n
the refrigerator is connected to a cold water pipe. See "Water
Supply Requirements."
Replacement Filters:
Do not use with water that is microbiologically unsafe or
of unknown quality without adequate disinfection before
or after the system. Systems certified for cyst reduction
may be used on disinfected waters that may contain
filterable cysts.
Standard Base Grille Water Filter Cartridge:
Part #4396841 (T2RFWG2 and P2RFWG2)
Write down the following information about your appliance to help
you obtain assistance or service if you ever need it. You will need
to know your complete model number and serial number. You can
find this information on the model and serial number label, located
on the inside wall of the refrigerator compartment.
Dealer name____________________________________________________
Serial number __________________________________________________
Address ________________________________________________________
Phone number __________________________________________________
Model number __________________________________________________
Purchase date __________________________________________________
6/09
Printed in Mexico