Troubleshooting - Truper SOPLA-26T Instructivo

Sopladora / aspiradora a gasolina
Tabla de contenido
Idiomas disponibles

Idiomas disponibles

Problem
Cause
Motor does not start.
• There is no spark.
• No fuel.
• The motor is flooded.
• The jack-line is difficult
to pull out when new.
The motor starts but
• The motor need a
does not accelerate.
couple of minutes to
warm up.
The motor starts but
• Carburetor need
runs only at high
adjustment.
speed with half a
choke.
• Check the oil / fuel
The motor does not
mix.
get to full speed and
• The air filter is dirty.
has too much smoke
• The spark arrest
emissions .
screen is dirty.
The motor starts, runs
• The idle speed screw
and accelerates but
in the carburetor needs
there is no idle speed.
adjustment.
12
ENGLISH

Troubleshooting

Solution
• Check the spark. Remove the motor cover. Remove the spark plug from
the cylinder. Connect the spark plug cable and set it onto the motor
cylinder with the metallic side touching the cylinder. Pull the starter and
watch the spark in the spark plug electrode. If there is no spark, repeat the
test with a new spark plug.
• Press the primer bulb until the fuel is visible in the bulb. If the fuel is not
visible, it means that the fuel primary supply system is blocked. Contact a
Authorized Service Center. If the starter choke is filled
with fuel, it means the motor is flooded.
• With the switches in the OFF position, remove the spark plug. Set the
choke lever in the "| | Run" position and pull the jack-line 15 to 2o times
to eliminate the excessive fuel from the motor. Clean the spark plug and
set it back. Follow the normal start up procedure (see page 8). If the
motor is not starting, set the choke lever in the "| | Start" position and
repeat the starting procedure. If the motor is still not starting, repeat the
procedure with a new spark plug.
• Take the tool to a
• Allow the motor to warm up completely. If there is no throttle after three
minutes contact a
• Take the tool to a
• Use new fuel and the right oil mix for 2-cycle motors.
• Clean the air filter. See page 10.
• Take the tool to a
• Turn the idle screw clockwise to increase speed.
Authorized Service Center.
Authorized Service Center.
Authorized Service Center.
Authorized Service Center.

Capítulos

Tabla de contenido

Solución de problemas

loading

Este manual también es adecuado para:

13047

Tabla de contenido