Steren CCTV-255 Manual De Instrucciones página 46

To delete a predetermined point, press DELETE
for 3 seconds. CLr- appears on the screen. Enter
the number or shortcut (HOME, A or B) you want to
delete. Press ENTER to confirm.
Once you have set up different points, you can set a movement pattern for
the camera. To begin to establish a route, press PATTERN for 3 seconds.
PStA is displayed to indicate that you are in the pattern set mode. Press, one
after another, the number of points you want to follow the pattern, pressing
ENTER after each number to confirm.
You can configure up to 16 different points. The speed at which the camera
goes from one point to another is 63 and will remain aiming to that point 8
seconds. When you have finished entering the sequence, press PATTERN
points for 3 seconds. The display will show PSt0 to indicate that the pattern
has been saved successfully.
To make the camera move through the points defined in the route, press
RUN. The display will show
PrUn. The camera will begin to
move along the pattern. To stop
it, press RUN again.
Press the AUTO key to make
the camera turn 360°. If you
want to stop it, press either the
arrow keys or ENTER. If you set
the A and B points, the camera
will move only between them.
20
ENTER
AUTO
ZOOM+
OPEN
IRIS
ZOOM-
CLOSE