Programming; General Parameters - Favero Electronics SPEAKER TIMER Manual De Instalacion Y Uso

ENGLISH
4.2. Selecting, starting and stopping a speaking time
To select a "speaking time":
press the [TIMER] key several times until the desired "speaking time" is displayed ("t1",
•
"t2", ..., "t9"), and
• within 3 seconds press [STOP]
Press [START] and [STOP] to start and stop timing. You can program timing forward or backward.
4.3. Modifying the timer
With the timer stopped: press [#] and then change its value with [+] and [-] (keeping them pressed, the
change is rapid, only for the local keypad). At the end, press [#] again to confirm the changes or press
the other keys to delete the changes.
4.4. Behavior when the speaking time expires
You can program the following operations:
(0) the timer stops; press [STOP] to recharge it and switch off the red light;
(1) the timer stops and is automatically recharged; press [STOP] to switch off the red light;
(2) the timer continues timing, an acoustic signal is emitted after 10 seconds and the red
light starts blinking; press[STOP] to switch off the acoustic signal and recharge the
chronometer.

5. Programming

You can set the specific parameters of each of the nine (9) "speaking times" and the general
parameters valid for all the "speaking times". Use the arrow keys [<] and [>] to scroll the parameters;
you can modify the values of these parameters with the keys [+] and [-] (on the local keypad, keep
them pressed to rapidly change the values).

5.1. General parameters

To access the programming functions press [PROG]. Press [PROG] or [ON-OFF] again to quit the
programming mode.
Identifier Description
Timing modes (dn: downward, uP: upward).
H1
H2 Sound type (trilling: 1, continuous: 2).
H3 Sound volume (off: 0, low: 1, medium: 2, high: 3).
1. Press [START] instead of [STOP] to start timing immediately.
8
/ 44
.
1
Parameter
00154-M01-ML - Speaker Timer User Manual Rev01 - 151029 -
Value
min default max
dn uP uP
1 2 2
0 2 3
FAV E RO E L EC T RO NIC S