Installing The Audio Connectors; Installing The Microphone; Installing The Remote Control - Parrot CK3000 EVOLUTION Guía De Instalación Rápida

Do not connect the orange wire to the permanent
12V, otherwise you can cause the vehicle battery
to go flat.

Installing the audio connectors

►
Refer to the installation diagram p.4 for more information.
• Car radio with ISO connectors:
1. Disconnect the ISO connectors of the car radio.
2. Wire the male connectors of the mute and power
cables to the car radio.
3. Wire the audio and power connectors of the car
to the female connectors of the Parrot CK3000
EVOLUTION wiring.
If the car radio is equipped with a Mute input, connect the
yellow wire of the audio cable to one of the "Mute in 1",
"Mute in 2" or "Mute in 3" inputs.
• Car radio without ISO connectors:
- You have to obtain an ISO cable to adapt your car
radio to the ISO connectors of the Parrot
CK3000 EVOLUTION.
- If you do not have an adapter, connect each wire in
turn if your vehicle does not have ISO connector
plugs. If the car stereo has a mute jack, connect using
the yellow wire of the mute cable.
6

Installing the microphone

Parrots microphones are directional and need to be pointed
towards the user to pick up clear speech. The microphone
should be installed near the front roof light cluster, in the
centre of the vehicle with a clear path to the user.

Installing the remote control

► Refer to the installation diagram p.4 for more information.
We advise you to fit the remote control where it
can easily be reached, preferably on a flat surface
that has first been cleaned.
Connect the mute cable to the connector provided on the
remote control. Ensure that the red and green LEDs light up
and switch off according to the position of the ignition key.