Tabla de contenido
Idiomas disponibles
Idiomas disponibles
TO CONVERTAPPLIANCEFOR USE WITH NATURALGAS
PropaneGas (LP) To NaturalGas
Conversion Instructions
If this appliance has been converted for use with LP Gas,
each of the following modifications must be performed to
convert the unit back to Natural Gas.
Model- JGD8348CDP
Manifold - Natural Gas pressure required - 5" W.C.
Incoming
Natural Gas pressure
required to appliance
pressure regulator - 6" - 7" W.C.
Natural Gas input specified - 56,000 BTU/hr.
A. Replace all orifice hoods - Perform steps 1 through 4 on
page 7. Locate the (6) six Natural Gas hoods (with small
numbers stamped on their sides saved from the original
Natural Gas unit). Page 5 Illustration "E". The two
hoods with .0520 (#55 orifice) stamped on them are for
the left front and left rear burners. The four hoods with
the .0595 (#53 orifice) stamped on them are for the two
right burners.
To make these
conversion
adjustments
follow
the
instructions
and illustrations
("A" through
"E") pages
5-7.
B. Invert
cap
in appliance
pressure
regulator
(see
Illustration "D", page 6). With the appliance installed,
the appliance pressure regulator is located on the right
underside
of the appliance
at the inlet to the gas
manifold.
Identify the type of appliance
pressure
regulator on the unit and follow the instructions in the
appropriate illustration.
C. Adjust low flame setting for each burner. Follow the
instructions for burner low flame adjustment on page 7
to increase the simmer flame size.
JGD8348CDP
BURNER
...........................
i
BTU/hr
ORIFICE
....
Left Rear (LR)
8,000
#55
Left Front (LF)
8,000
#55
Center Rear (CR)
10,000
#53
Center Front (CF)
10,000
#53
Right Rear (RR)
10,000
#53
Right Front (RF)
10,000
#53
DIAMETER
.0520
.0520
.0595
.0595
.0595
.0595
COLOR
Green
Green
Brass
Brass
Brass
Brass
Tabla de contenido
