Idiomas disponibles
Idiomas disponibles
t r a n s M i t t e r o p e r a t i o n
h a n d h e l d M i c o p e r a t i o n
1.
Unscrew the battery cavity (13) to open. Insert the two included
AA batteries into the battery cavity according to the polarity indi-
cation marked on the battery housing.
2. Press and hold power/mute button (14) to turn transmitter on. The
transmitter LED will light green.
FOR AUTOMATIC CHANNEL SELECTION:
1. Keep the battery cover open and point the transmitter
infrared (17) toward the IR receiver (8) and press Sync
control (6) button.
2. The antenna icon on the LCD display will be illuminated.
3. Close the battery cavity (13).
FOR MANUAL SETTING:
1. Press and hold the SELECT (15) button until the first two
digits (group number) begin to flash. Press SELECT to in-
crease group by increment from 0 to 33. After setting the
group number to match the receiver, wait 5 seconds until
the group number stops flashing.
2. Press and hold the SELECT button again. The last two
digits (channel number) start to flash. Press SELECT to
increase channel by increments of one from 0 to 33. After
setting the channel number to match the receiver, wait 5
seconds until the channel number stops flashing.
3. The microphone can be muted by pressing the Mic Power / Mute
button (14). If the microphone is not going to be used for any
length of time, press and hold the Mic Power / Mute button (14) to
power the microphone off. The mic will not need to be resynced
upon powering it back on.
18
U H F - 5 0 0 0
s e r i e s m a n U a l
•
g e m i n i d j
b e l t p a c k o p e r a t i o n
1.
Unscrew the battery cavity (13) to open. Insert the two included
AA batteries into the battery cavity according to the polarity indi-
cation marked on the battery housing.
2. Press and hold the belt pack power/mute button (18) to turn the
transmitter on. The transmitter LED will light green.
FOR AUTOMATIC CHANNEL SELECTION:
1. Keep the battery cover open and point the transmitter
infrared (17) toward the IR receiver (8) and press Sync
control (6) button.
2. The antenna icon on the LCD display will be illuminated.
3. Close the battery cavity (13).
FOR MANUAL SETTING:
1. Press and hold the SELECT (19) button until the first two
digits (group number) begin to flash. Press SELECT to
increase group by increments of one from 0 to 33. After
setting the group number to match the receiver, wait 5
seconds until the group number stops flashing.
2. Press and hold the SELECT button again. The last two
digits (channel number) start to flash. Press SELECT to
increase channel by increments of one from 0 to 33. After
setting the channel number to match the receiver, wait 5
seconds until the channel number stops flashing.
3. The microphone can be muted by pressing the Mic Power / Mute
button (18). If the microphone is not going to be used for any
length of time, press and hold the Mic Power / Mute button (18) to
power the microphone off. The mic will not need to be resynced
upon powering it back on.
.
U H F - 5 0 0 0
c o m
s e r i e s m a n U a l
.
•
g e m i n i d j
c o m
19
