Setting The Impact Force; Use; Switching On And Off; Stapling/Nailing - Parkside PET 25 C2 Manual De Instrucciones

Setting the impact force

NOTE
► Select the lowest impact force sufficient for
stapling. Take into account the length of the
staples or nails you are using as well as hard-
ness of the material you are working with.
Impact force control
Increasing the impact force:
♦ Turn the impact force control
Reducing the impact force:
♦ Turn the impact force control

Use

Switching on and off
♦ Set the ON/OFF switch
switch the appliance on.
♦ Set the ON/OFF switch
switch the appliance off.

Stapling/nailing

♦ Switch the appliance on by moving the ON/
OFF switch to the position "I".
♦ Press the face plate
the location on the material that you want to
staple/nail.
♦ Press the trigger
NOTE
► The integrated safety switch on the face plate
prevents accidental triggering.

Working with the rip fence

If you want to tack with nails or staples at a con-
stant distance to an edge, proceed as follows:
│ GB │ IE
■ 16
anticlockwise.
clockwise.
to the position "I" to
to the position "0" to
of the appliance onto
.
♦ Pull out the rip fence
arrow.
♦ Move the rip fence
is at the required distance from the edge of the
object that you want to work on.
♦ Place the rip fence
object that you want to work on.
♦ Proceed as described in the section Stapling/
nailing.

Troubleshooting

CAUTION!
► Ensure that the appliance has been discon-
nected from the power in order to prevent
it from being accidentally switched on and
causing injuries.
Cause:
A staple or nail is blocking the appliance.
Solution:
♦ Open the magazine slider
the tension. Use the hex key (fig. D) to remove
the screws from the face plate
♦ Remove the staple or nail.

Maintenance and cleaning

WARNING! RISK OF INJURY
► Always remove the plug from the power
socket before working on the appliance.
The electric staple gun is maintenance free.
■ The appliance must always be kept clean, dry
and free from oil or grease.
■ Always clean the appliance directly after finish-
ing work.
■ Never permit liquids to enter inside the appli-
ance.
■ Use a cloth to clean the housing. Never use
petrol, solvents or cleansers which can damage
plastic.
in the direction of the
along the scale until it
onto the edge of the
. This will remove
.
PET 25 C2