golmar SV-1370 SII Manual De Instalación página 40

POWER SUPPLY INSTALLATION
D
etail of the FA-122 power supply installation and technical features.
3,5 x 25
DIN-7971
The power supply can be installed on a DIN 46277
guide simply pressing it To disassemble the power
supply from the DIN guide, use a plain screwdriver
to lever the flange as shown on the picture
The FA-22 power supply uses 3 units over DIN guide.
This device has been exclusively designed to be used on Golmar Kit video
Golmar will not be responsible of the possible damages caused for an improper use or when used
for other purposes than the specified. Install the power supply according to your country rules.
IMPORTANT: Replace the protection cover once the input terminals have been wired.
LOCK RELEASE INSTALLATION
L
ock release installation.
If the lock release will be installed in a metal door,
use a Ø3,5mm. drill and tap the hole
In case of wood door, use a Ø3mm. drill
IMPORTANT:
The lock release must be 12V direct current (cod. 20600149), see
Optionally lock release 12Vac with TF104 transformer and SAR-12/24 relay (see page 46).
3,5 x 25
DIN-7971
To install the power supply directly on the wall, drill two
holes of Ø6mm. and insert the wallplugs Fix the
transformer with the specified screws
.
Technical features
Input
Power
Output
Working temperature
Dimensions
Weight
The power supply must be installed in a dry and
protected place It's recommended to protect .
the power supply by using a thermo-magnetic
circuit breaker and to use a ground connection
.
DIN 46277
230 Vac / 50 Hz
25 VA
17 Vdc 1,5A
0ºC ~ + 35ºC
54(W) x 83(H) x 58(D) mm.
130 gr.
.
.
.
.
SV-1370 SII Colour
3,5 x 25
DIN-7972
M 4 x 8
DIN-963
page 45 .
39
.
.