Unpacking And Installation; Unpacking; Packing List; Location - Fisher Scientific Isotemp 13-247-10 Manual Del Usuario

Unpacking and Installation

Quantity
Small Medium Dual
1 1
1 1
1 1
1 1
1 1
2 2
1 1
1 1
1 1
0 0

Unpacking

Each hybridization incubator is shipped in a single carton.
When unpacking the unit, check each item against the pack-
ing list below. If something is missing, contact Fisher cus-
tomer service at 1-800-766-7000, identifying the part by
name and catalog number.
Part numbers are listed in the Replacement Parts and
Accessory Items sections located at the end of this manual.

Packing List

Item supplied
1 Hybridization incubator
2 Drip tray
2 Rotisserie
1 35mm x 150mm hybridization tube (Cat. No. 13-247-150)
1 35mm x 300mm hybridization tube (Cat. No. 13-247-300)
4 Spare tube clips
1 Power cord
1 Instructions
1 Warranty card
1 Wall Bracket

Location

Follow these guidelines when choosing a location for the
hybridization incubator. The location must:
• Provide an adequate source of power. Check the
label on the back of the unit for voltage and current
requirements.
• Provide minimum air clearance as follows: 0.5 inch
(13 mm) from top, 2 inches (51 mm) from back, and
2 inches (51 mm) on each side.
• Provide adequate clearance for loading and unload-
ing samples.
9