Operating Characteristics; Power Connection; Heating Plate; Fluid Basin-Thermabasin™ Technology - Ecolab IntraTemp Manual Del Operador

The ITW6L is intended for use in the electromagnetic environment in which radiated RF disturbances are controlled.
The customer or the user of the ITW6L can help prevent electromagnetic interference by maintaining a minimum
distance between portable and mobile RF communications equipment (transmitters) and the ITW6L as recommended
below, according to the maximum output power of the communications equipment.
Rated maximum output
power of transmitter
W
0.01
0.1
1
10
100
For transmitters rated at a maximum output power not listed above, the recommended separation distance d in meters (m) can be estimated using
the equation applicable to the frequency of the transmitter, where P is the maximum output power rating of the transmitter in watts (W) according to
the transmitter manufacturer.
NOTE 1–At 80 MHz to 800 MHz, the separation distance for the higher frequency range applies.
NOTE 2–These guidelines may not apply in all situations. Electromagnetic propagation is affected by absorption and reflection from structures,
objects, and people.
Catalog Number Description
ITW6L IntraTemp Solution Warmer
ITNA15 Power Cord Kit, IntraTemp, North American Hospital Grade, 4.6 m (15 ft)
ITNA25 Power Cord Kit, IntraTemp, North American Hospital Grade, 7.6 m (25 ft)
ITUK15 Power Cord Kit, IntraTemp, United Kingdom, 4.6 m
ITUK25 Power Cord Kit, IntraTemp, United Kingdom, 7.6 m
ITEU15 Power Cord Kit, IntraTemp, European Union, 4.6 m
ITEU25 Power Cord Kit, IntraTemp, European Union, 7.6 m
ITB100 Ecolab ThermaBasin: Basin with Attached Drape for use with the IntraTemp Solution Warmer

3. OPERATING CHARACTERISTICS

3.1

Power Connection

The IntraTemp Solution Warmer is designed to work when connected to a 120 VAC 60 Hz Power
Source (North America) or a 230 VAC 50 Hz Power Source (UK, Continental Europe). A power cord
specific to an applicable region must be ordered with the IntraTemp Solution Warmer.
3.2

Heating Plate

The IntraTemp Solution Warmer warms fluid contained in a basin via a specially designed ThermaBasin
heating plate. The heating plate is located at the top of the warmer in the basin receptacle. After use,
allow the heating plate to cool before cleaning. Avoid contact until the plate cools.
3.3 Fluid Basin - ThermaBasin™ Technology
IntraTemp is designed to operate with a proprietary Ecolab ThermaBasin with a unique thermal well molded
into its bottom. This molded thermal well protrudes upward from the disposable ThermaBasin bottom and
mates with the warmer's Safety Switch thermocouple to measure and maintain fluid temperature. Only Ecolab
ThermaBasin can be used with the IntraTemp warmer. The use of any other basin may damage or disable
the IntraTemp warmer.
Recommended separation distances between
portable and mobile RF communications equipment and the ITW6L
Separation distance according to frequency of transmitter
150 kHz to 80 MHz
d=1.2√P
0.12
0.38
1.2
3.8
12
m
80 MHz to 800 MHz
d=1.2√P
0.12
0.38
1.2
3.8
12
7 of 128
800 MHz to 2.5 GHz
d=2.3√P
0.23
0.73
2.3
7.3
23