Dip-Switch Confi Guration; Video Door Phone Code; Call Button To Video Door Phone Association; Line Terminal - Urmet mini note + 1722 Serie Manual De Instrucciones

7.2. DIP-SWITCH CONFIGURATION
7.2.1

Video door phone code

Set the respective address using the dip switches on each apartment station to install "Slave" video door phones.
Type of video door phone
"Master" video door phone
"Slave" 2 video door phone
7.2.2

Call button to video door phone association

Video door phone associated
with the call button 1
7.2.3

Line terminal

The line termination must be activated on a video door phone connected at the end of a line without a new section restarting from the LINE OUT
terminals.
Terminal insert (default)
7.3.

INSTALLATION COMPLETION

Connect.
Fix the video door phone to the bracket.
1
2
7.4.

PROGRAMMING THE INTERCOM FUNCTION

The system offers the option of programming 2 buttons (1
With the kit Ref. 1722/83 you can call up to 2 video door phones in the same apartment.
With the kit Ref. 1722/84 you have two calling options:
• up to 2 video door phones in the same apartment,
• 1 video door phone in the same apartment and all video door phones of the other apartment.
To programme the buttons:
• Go to the indoor station to be programmed as caller (indoor station A).
• Press and hold for more than 5 seconds; the red LED will fl ash slowly and the system will emit 3 confi rmation beeps to confi rm the new
setting.
• Press the button to be programmed as "caller" (
• Go to the indoor station to be called by that button (indoor station B) and press the door-key button. The indoor stations A and B will emit a
beep to confi rm the new setting.
• To exit the programming mode, press and hold
In any case, after 10 minutes the device will automatically quit the programming mode, saving the edited parameters.
With the kit Ref. 1722/84, the call to a video door phone in the second apartment will necessarily sound all video door phones in
the apartment.
DS1722-098A
Dip switch position Type of video door phone
ON
"Slave" 1 video door phone
1 2 3 4
ON
"Slave" 3 video door phone
1 2 3 4
Dip switch position
ON
Video door phone associated
with the call button 2
1 2 3 4
Call button 1
→
Dip switch position
ON
Terminal not inserted
1 2 3 4
To remove the video door phone from the bracket,
insert the tip of a screwdriver into the seating as
indicated in the fi gure and push the video door phone
upwards.
and
or ) for at least 3 seconds until you hear the confi rmation tone.
for more than 5 seconds on the indoor station A.
Call button 2
←
) to make intercom calls.
Dip switch position
ON
1 2 3 4
ON
1 2 3 4
Dip switch position
ON
1 2 3 4
Dip switch position
ON
1 2 3 4
1
2
21