Tabla de contenido
Performance
Flow Capability
Maximum Dry Vacuum
Minimum Lift**
Maximum Viscosity of fluid pumped
Maximum ambient operating temperature 150 °F (66 °C)*
Minimum ambient operating temperature -15 °F (-26 °C)*
* Consult factory for extreme temperature applications outside this range.
** The lift in feet is equivalent to the vertical distance from the surface of the fluid in the tank to the inlet
of the pump, PLUS the friction losses through the vertical and horizontal runs of pipe. All elbows and
other fittings must be included in the calculation of friction loss. The system should be designed to
require a minimum amount of suction lift.
*** Lift of gasoline dependent on Reid's vapor pressure of the gasoline and it's temperature. The lower
the vapor pressure and temperature, the higher the possible lift. Refer to the attached Practical
Gasoline Suction Lift Considerations to determine the gasoline lift you can expect.
CAUTION: Only pump as clearly carrying the UL Listing Mark should be used with gasoline or
any low flashpoint fluid. Look for the Mark.
Fluid Compatibility
The Series 100 Rotary Hand Pumps are designed for petro products of all types. If there is a question
for a particular fluid, check the affects of that fluid on the following wetted materials.
Cast Iron Steel
Acetal
Viton® Vellumoid
Nylon- 110, 120, 112, and 122 Only
Zinc Plated Steel
Also
10.3 Ounces (0.306 Liters) per Revolution.
6" of Mercury
8' of Diesel. For gasoline see below.
SAE30 Motor Oil
Tabla de contenido
