Krups JC200850 Manual Del Usuario página 17

KR_WINE_DISPENSER_NAFTA_NC00119132_NC00119132 18/07/13 08:37 Page19
Problem
11. There are bubbles
moving from the bottle
tube into the bottle of
wine.
12. The wine bottle will not
securely install onto the
locking piston assembly.
Chilling
13. The temperature inside
the cooling chamber is
not as cold as expected.
Noise
14. Noise from machine.
Clogging
15. Clogged situations
happened by wine
residue or after
prolonged use.
Spillage
16. Liquid (such as water
condensation or wine) on
the countertop.
Recommended Steps
- Ensure that the check valve is securely tightened to the
cartridge head.
- Clean the cartridge head by running water-cleaning
procedures and recheck the seal.
- Ensure correct type of bottle(s) is/are used. The cartridge
is not suitable for screw top bottle(s) unless a specially
fitted accessory (i.e. screw top head) is used. The screw
top accessory is sold separately.
- Ensure that the locking piston handle is in an open
position, which enables you to insert the bottle tube into
the bottle and install the bottle securely onto the locking
piston assembly (5).
- Press the locking piston handle in a closed position to
ensure it is attached to the bottle (6).
- Ensure the glass door has been closed properly to
prevent leakage of cool air from the chilling chamber.
- Ensure the expected wine temperature setting was set
properly through the control panel of the machine.
- Ensure the air filter from the back side of the machine is
clean and free of dirt sticks on the filter.
- The humming sound coming from the cooling fan is
continuous and to be expected when the machine is left
on.
- The sound comes from the pump when it vacuums the
air inside the wine bottle after dispensing the wine.
- Ensure the filters/valves are cleaned regularly.
- Ensure the wine dispensing system is cleaned between
each bottle of wine.
- Ensure no hard water and improper cleaning/rinsing
agents are used during the cleaning process.
- There could be water inside the air tubing system linked
to the use of beverages not fit to use with the machine.
Ensure that there is no hot water (other than for rinsing),
carbonated or sparkling liquids used in the machine.
- Ensure the drip tray is in place.
- Wait an additional 5 s before removing your glass from
the dispensing head.
19