Storing The Appliance; Repairs; Troubleshooting - Krups JC200850 Manual Del Usuario

KR_WINE_DISPENSER_NAFTA_NC00119132_NC00119132 18/07/13 08:37 Page17
2. Fill the 2 empty wine bottles with clean water
affect the flavor of
3. Insert the locking pistons into the 2 wine bottles (with clean water) (16).
4. Insert the 2 locking pistons (with 2 wine bottles) into the wine dispenser cooling chambers
(17).
5. Prepare a container to hold the water.
6. Turn on the wine dispenser.
7. Run the normal dispensing process with the clean warm water so as to let the water clean
the tubes inside the wine dispenser (18).
8. Stop the dispensing process until all the water is poured out from the bottles inserted in
the wine dispenser.

Storing the appliance

When the appliance is not to be used for a long period of time, turn the main switch off and
pull out the plug.
Before storing the appliance, rinse the system with fresh water and let it dry open.
Store the appliance in a dry place out of children's reach.
Protect it from dust and dirt.

Repairs

Should a breakdown, fault or suspected fault occur after the appliance has been
accidentally dropped, immediately pull out the plug.
Never operate a faulty appliance.
All servicing and repairs must be carried out by an authorized service center.
The manufacturer will not be liable for any injury or damage to persons and/or property
caused by the appliance malfunctioning should repairs not be performed by an authorized
service center.
Problem
Power
1. The wine dispenser does
not turn on.
2. The wine dispenser turns
on but an individual
chamber is not working.
3. Blue light is flashing.
LCD Display
4. Nothing is displayed on
the LCD Display.
5. Malfunction on LCD
Display
wine).

TROUBLESHOOTING

Recommended Steps
- Ensure the wine dispenser is plugged into the outlet.
- Ensure that the outlet has power.
- Ensure the main power button is "ON".
- Ensure the individual chamber power buttons is "ON".
(13)
- Ensure there is proper voltage supply.
- Ensure the individual chamber power buttons is "ON".
(13)
- Open and close the glass door to reset.
- Remove the locking piston assembly and wash it
thoroughly and then replace.
- Ensure that the main power button is on and there is
power to the machine.
- Re-start the wine dispenser by pressing the main power
switch at the back of the machine.
(DO NOT USE soap water as this may
17