Troubleshooting - Metcal PS-900 Guia Del Usuario

6. REPLACING COIL ASSEMBLIES
1.
Push the Power Switch "Off." Wait for the heater tip to reach room temperature.
2. Remove the heater tip from the handle assembly. DO NOT USE METAL TOOLS (SUCH
AS PLIERS) TO REMOVE HEATER TIPS.
3. To disconnect the Coil Assembly from the Soldering Handle depress the button on the Coil
Assembly and pull it away from the Soldering Handle assembly.
4. Insert the new Coil assembly into the handle assembly, you will feel a 'click' as it seats.

7. TROUBLESHOOTING

a. Power LED Not ON



b. Tip Does Not Heat





If you cannot resolve the problem after conformation of the above, please contact your local OK
International representative.
Check the power cord
Check to see that you have mains voltage
Check to see if the power switch is in the ON position
Is the LED Illuminated?
Is the Hand-Piece Connected to the Power Supply?
Is the PS-CA3 Coil assembly firmly inserted into the PS-H3 Soldering
Handle assembly?
Is the Tip Firmly Inserted onto the PS-CA3 Coil Assembly?
Has a replacement PS-CA3 been tried?
www.metcal.com
4