Philips PT927 Manual Del Usuario página 21

Problem Possible cause
The temperature of the shaver is too
high. In this case, the shaver does not
work.
The cleaning luid in the cleaning
The shaver is not
entirely clean after chamber is soiled.
I clean it in the
Jet Clean System
(PT927CC/
PT923CC only).
The cleaning luid level is too low.
If the luid volume in the cleaning
chamber drops below the minimum
level during the cleaning program, the
program aborts.The cleaning symbol
and the 'luid low' symbol lash at
intervals and the holder returns to its
starting position.
You have used another cleaning luid
than the original Philips cleaning luid.
You have not closed the locking lever
of the Jet Clean System properly, or
you have not placed the shaver in the
Jet Clean Shaver properly. In these
cases the Jet Clean System starts to
operate, but the cleaning program is
not performed properly.
The Jet The Jet Clean System is not connected
Clean System to the mains.
(PT927CC/
PT923CC
only) does not
work when I press
the on/off button.
Water leaks from This is normal and not dangerous.
the shaver after
cleaning.
Solution
As soon as the temperature of the shaver
has dropped suficiently, you can switch
on the shaver again.
Empty and rinse the cleaning chamber
(see chapter 'Cleaning and maintenance').
Reill the cleaning chamber with cleaning
luid up to the MAX level (see chapter
'Cleaning and maintenance').
Only use Jet Clean solution HQ200.
Place the shaver without protection cap
in the Jet Clean System properly. Close
the locking lever properly.
Put the small plug in the Jet Clean System
and put the adapter in the wall socket.
During rinsing some water may collect
between the power unit and the housing.
After rinsing this water lows out through
the socket. The power unit is completely
watertight so water cannot reach the
electronic parts of the shaver. Your shaver
continues to be absolutely safe.
English
21