Cleaning And Care; Troubleshooting - Klarstein 10030540 Manual De Instrucciones

Cleaning your wine cooler
• Unplug the wine cooler and remove the bottles.
• Wash the inside with a warm water and baking soda solution. The solution should be about 2 tablespoons
of baking soda to a quart of water.
• The outside of wine cooler should be cleaned with mild detergent and warm water.
• Draw out the water box at the bottom, and wash.
Moving your wine cooler
• Remove all the bottles.
• Securely tape down all loose items inside your wine cooler.
• Turn the leveling legs up to the base to avoid damage.
• Tape the door.
• Be sure the wine cooler stays in the upright position during transportation.
Moving Shelves
• To prevent damaging the door gasket, make sure
the door is fully opened when pulling shelves out
of the rail compartment.
• For easy access to the storage content, you must pull
the shelves approximately ⅓ out of the rail com-
partment. This unit is designed with a notch on each
side of the shelf tracks to prevent bottles falling out.
• When removing any of these shelves out of the rail
compartment, tilt the shelf as per the diagram and
simply pull it out. The same method for pushing in
the shelf until it sits on the support brackets firmly.
Problem
Wine cooler do not operate.
Wine cooler is not cold enough.

Cleaning and Care

Troubleshooting

Possible Cause
Not plugged in using different voltage. The circuit breaker tripped or a
blown fuse.
Check the temperature control setting.
External environment may require a higher setting.
The door is open too often.
The door is not closed completely.
The door seal does not seal properly.
The wine cooler does not have the correct clearance.
8