Self-Test Error Messages; Additional Options Available - Genicom 5000 Serie Guía De Referencia Rápida

Self-test Error Messages

ADDITIONAL OPTIONS AVAILABLE

5000 Series Quick Reference Guide
Self-test diagnostics are run:
• During the power-on sequence.
• After initialization using the control panel.
•
After printing.
• When requested from the host by the ESC Q escape sequence. (See
5000 Series Programmer's Manual for information on escape sequences.)
The error message is used only in the ANSI emulation while using
the serial interface. When an ESC Q escape sequence is received,
the printer performs a self-test and sends the appropriate error
message to the host if a fault is found. DCS = ESC P and ST = ESC \.
See 5000 Series Programmer's Manual for information on the ANSI
emulation and escape sequences.
A complete listing of the options available in this printer can be found in
the User's Manual, Appendix D. These items may be obtained from an
authorized GENICOM distributor, service agent, or from GENICOM
headquarters at the following address:
When ordering, specify description, part or catalog number, and the
quantity desired. See the User's Manual, Appendix D for the available
items.
Note
GENICOM L.L.C.
Parts Sales
1 Genicom Drive
Waynesboro, Virginia 22980-1999
1-800-535-4364
FAX: (540) 949-1890
Electronic Bulletin Board: (540) 949-1576
or www.genicom.com/drivers/index.html
(Check for current printer drivers and the
updated replacement and spare part listings)
37 GEK-99012D