Installation And Removal Of Ribbon - 55 Dba (5180) Cabinet Model - Genicom 5000 Serie Guía De Referencia Rápida

INSTALLATION AND REMOVAL OF RIBBON – 55 DBA (5180)
CABINET MODEL
Positioning Pin
Located Under Here
Horizontal
Adjust Knob
Guide Cartridge
Onto
Positioning Pin
5000 Series Quick Reference Guide
Use the following procedure to install a ribbon on a 5180 (55 dBa
Cabinet) Model printer:
1. Lift the top cover of the printer.
2. If the thickness of the paper will remain the same after the ribbon
cartridge is installed, note the present position of the paper gap
adjust knob.
Print Gap
Adjust
Wheel
3. Turn the paper gap adjust knob clockwise to the LOAD position.
4. Turn the knurled knob on the new ribbon cartridge clockwise to
remove any slack in the ribbon.
Hole for
Positioning
Pin
Bottom Knob for Tightening Ribbon
Top
26
Smudge
Shield
Ribbon
Reinker
Pin
(Clockwise)
GEK-99012D