Tabla de contenido
Idiomas disponibles
Idiomas disponibles
To Drain
Tank
1.
Set the On/Off switch to OFF (O).
2.
Pull the regulator knob out and
turn counterclockwise
to set the
outlet pressure to zero.
3.
Remove the air tool or accessory.
4.
Pull ring on safety valve a!lowing
air to bleed from the tank until
tank pressure is approximately
20
psi. Release safety valve ring.
5.
Drain water from air tank by
opening drain valve on bottom of
tank.
_
Water will
condense
in the
air tank, If not drained, water wHm
corrode
and weaken
the air tank
causing
a risk of air tank rupture,
6.
After the water has been drained,
close the drain valve. The air
compressor can now be stored.
NOTE: If drain valve is plugged,
release all air pressure.
The valve
can then be removed, cleaned, the
reinstalled.
ALL MAINTENANCE AND REPAIR OPERATIONS NOT LISTED MUST BE
PERFORMED BY TRAINED SERVICE TECHNICIAN.
_Risk
of Unsafe Operation,
Unit cycmee automatically
when
power is on, When servicing,
you may be exposed
to
vomtage sources,
compressed
air, or moving parts, Before servicing
unit
unplug or disconnect
electricam supply to the air compressor,
bracedtank of
pressure,
and allow the air compressor
to cool
To Replace
or Clean Check
Valve
1.
Release all air pressure from air
tank. See "To Drain Tank" in the
Maintenance section.
2.
3.
Unplug unit.
Remove the hose by removing
the hose clamp. NOTE: The hose
clamp is not reusable. You must
purchase a new hose clamp, see
the Parts List Manual or purchase
a standard hose clamp at a local
hardware store.
Hose Clamp
Cheek
Valve
Unscrew the check valve (turn
counter-clockwise)
using a
socket wrench.
15-ENG
A10282
Tabla de contenido
