Lanaform Dehumidifier Manual Del Usuario página 5

• The dehumidifier must be placed as close as possible to the source of humidity.
• To reduce the noise and vibrations produced by the appliance, we recommend the use of an anti-vibrations mat. These
mats are available from specialist stores.
INSTALLATION OF THE WATER TANK
Check that the water tank is empty prior to each use.
Empty the tank following the instructions below:
• Check that the appliance is turned off and unplugged
before draining the tank.
• Place your hand on the bottom of the dehumidifier
and remove the base (1).
• Remove the cover located above the tank and empty
the water (2).
• Replace the cover before refitting the tank.
When the water tank is full, the appliance will immediately cease to operate. The water tank icon (21) will start
Notes:
to flash and the alarm will sound 15 times.
INSTALLATION OF THE DRAIN PIPE
If the appliance is used in a very humid environment,
your appliance may be equipped with a permanent
drainage connection (supplied) as shown below:
• Cut the cover behind the appliance using scissors or a
pair of pliers (not supplied) (1).
• Insert the pipe (supplied) in the drainage hole and
check that the pipe fits to avoid any risk of water
leakage. (2)
INSTALLATION OF THE CARBON FILTER
The dehumidifier is fitted with a carbon filter in addition to the air filter located under the grid. This carbon filter clears
the room of unpleasant odours. Follow the instructions below to install the carbon filter:
• Open the compartment (1).
• Place the carbon filter over the air filter as shown on the diagram (2).
• Replace the filter in the compartment (3).
1
It is not necessary to fit the carbon filter when you use the appliance to dehumidify air in a room. In fact, the
Note:
absorption capacity of the air is reduced if the carbon filter is fitted.
1
1
2
2
3
Dehumidifi er
EN
2
5