Tabla de contenido
Idiomas disponibles
Idiomas disponibles
16. This heater draws 12.5 amps during operation. To prevent overloading a circuit,
do not plug the heater into a circuit that already has other appliances working.
17. Do not use outdoors
"SAVE THESE INSTRUCTIONS"
UNPACKING AND SET-UP INSTRUCTIONS
CAUTION: Risk of fire – Do not operate heater without wheel assemblies
attached. Operate in upright position only (wheel on bottom, controls on top).
Any other position could create a hazardous situation.
Unpack your heater and remove the wheel assemblies from the package.
Refer to Figure 1 below:
Make sure heater is unplugged and in the "OFF" position.
1.
2.
TURN THE HEATER UPSIDE DOWN.
3.
Unscrew nut on wheels and attach wheels to wheel base. Secure
tightly.
4.
Insert U-bolt around bottom of heater pointing upwards and into
existing holes of wheel base. U-bolt should only be placed in first and
last opening between fins. (Figure 1)
5.
Secure 2 wheel bases to U-bolts with 4 wing nuts. Secure tightly with
fingers.
6.
TURN HEATER UPRIGHT.
NOTE: Please allow your heater ample time to warm up to heating
temperature.
NOTE: A protective heat shield is mounted to the rear of this heater. This
is an important safety feature and should not be removed. Due to this
shield the rear fin may not feel as hot as the other fins. This is normal.
PLEASE READ BEFORE OPERATING
This End Up
Wheel Base
Wheel Assembly
Fig.1-Upside down view
Wheel caster
U-shape screw
3
Tabla de contenido
