5.11 LEVELLING THE FURNACE AND INSERTING THE MAGNOFIX TOP PANELS
The stove is equipped with wheels that facilitate its positioning. Once settled in its final position it must be levelled,
with the aid of a spirit level, adjusting the feet (fig. 5.11) and ensuring that the wheels are raised above the ground.
Proceed at the same time with the regulation of the frame that supports the side tank.
For correct positioning, check that the front marble cover profile is at a height such as to be in contact with any
marble surface of the casing.
Open the furnace door and correctly insert the two magnofix top panels (Fig. 5.11a).
5.12 ELECTRICAL CONNECTIONS
In order to function, the stove needs an electrical power supply. (Fig. 5.12)
`
It is sufficient to connect the product to the electrical system using the plug provided.
The electrical connection (plug) must be easily accessible after installation of the stove.
If the power cable is damaged it must be replaced by the technical support service or by a qualified technician
so as to prevent any risk.
Pay attention so that the power cord does not come into contact with hot parts.
5.12.1 Earthing
It is mandatory that the system is earthed and equipped with a residual-current device in compliance with the
regulations in force. The flue must also be grounded in accordance with the UNI 10683 standard.
5.12.2 Installing the control panel
The stove's control panel can be mounted into a plasterboard wall by cutting a hole (105x60mm) and fitting its
mounting bracket (included) to its back with the two bolts (fig. 5.12).
Do not install the panel in a hot area of the hood.
Run the cable between the panel and the stove in such a way that it is not damaged by heat when the stove is
running stove is running and does not interfere with the electro-mechanical components.
The control panel hooks up with its cable (included) to connector RJ11 on the electronic panel (fig. 5.12.3).
5.12.3 Connection to the connection box (optional)
The connection box allows communication with the stove through its own mobile device, downloading the
appropriate App.
Connect the connection box to the RJ11 connector on the electronic panel (fig. 5.12.3).
Follow the instructions contained in the package for the installation of the device.
fig. 5.11
004776370 - 31/01/2019 - PALAZZETTI - PN - ITALY
fig. 5.11a
31