Tabla de contenido
ELECTRONICAL CONTROLLER
10.5 TRAMLINING - C3
The displays defaults to the
Total was selected).
There are five systems of tramlining - symmetric, asymmetric left, asymmetric
right, 10 bout and 18 bout. The tramline bout is programmable from 1 to 15
in symmetric, asymmetric left and asymmetric right sequences.
Selection of asymmetric tramlining is denoted by a decimal point on the
display between the current bout number on the left and the tramline bout
number on the right. Left or right asymmetric tramlininig is selected in the
programming mode.
Manually advance the bout number
Press
current bout number by 1.
Hold the bout number
Press
current bout when the drill goes
out of work.
The display will flash 'STOP'.
Press
normal bout sequence.
to advance the
to "hold" the
again to resume the
64
channels after 10 seconds (unless the Area
Tabla de contenido
