Maintenance; Filter; Easy To Replace Filter; Installation - Workshop WS0250VA0 Manual Del Usuario

SP6848-2 Workshop WS0250VA0:SP6439-3_ES.qxd 7/23/13 9:10 AM Page 10

Filter

Your filter should be cleaned often to
maintain peak Vac performance.
NOTE: The filter is made of high quality
material designed to stop small particles
such as sawdust. Handle the filter
carefully when removing to clean or
installing a new filter. Do not tear the filter
during removal or installation if your intent
is to reuse the filter.

Easy to Replace Filter

1. Remove the retainer band and the
filter bag off the filter cage.
2. Place the replacement filter on the filter
cage until open end touches bottom of
lid.
3. Install the retainer band around the
filter bag, locating it over the rib tabs on
the filter cage.
IMPORTANT: To avoid damage to the
blower wheel and motor, always reinstall
the filter before using the Vac for dry
material pick-up.
Take the dirty filter to a disposal container
and gently brush away small dirt particles
that may be adhering to the filter material.
IMPORTANT: After cleaning, check the
filter for tears or small holes. Do not use a
filter with holes or tears in it. Even a small
hole can allow a lot of dust to come out of
your Vac. Replace it immediately.

Installation

Before installing the filter on the Vac,
clean the area of the lid so that the
retainer band will seal the bag against the
lid and stop small particles from
bypassing the filter bag.
If the filter is clean and not damaged,
replace it on the filter cage. If it cannot be
reused, place a new filter over the filter
cage.
Replace the retainer band around the

MAINTENANCE

Filter
Rib Tab
Retainer
Band
filter. Make sure the retainer band is
positioned on the filter, and the filter
completely covers the filter cage. Also,
make sure the edges of the filter are
completely secured under the retainer
band.
NOTE: Clean the filter in an open area.
Cleaning should be done outdoors and
not in the living quarters.
WARNING: Do not remove the
filter cage and float. The float
prevents liquid from entering the
impeller and damaging the motor.
The cage prevents fingers from
touching the moving impeller.
10
POWER HEAD
(upside-down)