TCL TTW-08CR/UF Manual Del Usuario página 8

Direct Unit Mounting
In case where the dual intake grille cannot be mounted directly to the sleeve it is desirable to attach the grille to
the back of the TTW unit to the hole predrilled in the unit.
1. Attach the 2 seals(1''x3/8''x14''), as shown in Fig. 1.
2. Position the grille over the rear of the unit making sure that:
a.The double set of screw holes are at the bottom.
b.The intake fins on either side are pointed away from the unit.
3. Align the top of the grille with the top of the unit. The overhang on each side is equal.
4. If the unit has not been predrilled (some models), carefully drill 4-1/8'' holes through the grille and into the side
flange of the unit approximately 1 1/2'' to 2'' from the top and bottom, as Fig. 2 and 3 show. (Be careful not to
break the copper pipe)
5. Install 4-#8 self-tapping screws to affix the grille to the unit.
6. Insert the unit into the sleeve.
Grille to Sleeve Attachment
In case where the dual intake grille fits inside the sleeve and the grille flange overlaps the sleeve flange, direct
attachment may be possible.
IMPORTANT
If the suitable grille is not used, it may lead to product damage and possible failure.
6