Cavalier 1995-1999 - Dynex DX-G1113 Guia Del Usuario

Installing your car stereo
Chevrolet

Cavalier 1995-1999

To install your car stereo:
1 Disconnect the negative battery terminal to prevent an accidental short circuit.
2 Open the passenger's door, then remove the panel on the end of the dash.
3 Remove move one exposed Phillips screw on each side.
4 Remove three 7 mm hex-head screws from the top of the glove box liner.
5 Remove two 7 mm hex-head screws from the top left corner of the glove box
compartment.
6 Remove one Phillips screw from the defroster duct.
7 Remove the duct work and the one exposed Phillips screw.
8 Remove the dash pad and three exposed Phillips screws at the top of the radio trim
bezel.
9 Locate bracket set 10.
10 Go to "Completing the installation" on page 76.
35