Device Elements - Kathrein UFOmini 87 Manual Del Usuario

Arrangement and function

Device elements

1
2
Fig. 1: Device elements
①
4 x Sat-IF input, F socket
②
1 x terrestrial/cable input, F socket
③
Screw for fixing to the wall mounting plate
④
Test output, signal level –25 dB, F socket
⑤
DVB-C output, F socket
⑥
Network port, RJ45
⑦
USB port, type B, communications interface UFO link for connection to the UFOmini master
⑧
2 x USB ports, type A:
USB: Software update by USB stick
UFO link: Communications interface UFO link for connection to the UFOmini slave
The power supply cable is integral to the device and is not shown here.
1)
If the head-end is the slave; see below for more info Cabling, P. 5.
2)
If the head-end is the master; see below for more info Cabling, P. 5.
3)
LEDs and reset button
Master LED
Reset button
Press < 5 s
Press > 5 s
Press > 5 s
To prevent accidental activation, the reset button is recessed. To activate the reset button, use a tool such as a ball-point pen.
1)
Pre-requirement: There is a valid update file on the USB stick. See the USW 800 configuration software for more info.
2)
3 / 8
11
12
13
10
9
8
7
6
5
4
3
green the head-end is the
master
off the head-end is a slave
the head-end will reboot.
1)
the head-end will reset to the factory settings and will reboot. Do not release the
1)
reset button until the status LED lights up orange.
the head-end will look for an update on the connected USB stick, perform the
1)
update and reboot.
USB
8
UFO Link
⑨
Earthing screw
⑩
Power supply
⑪
Master LED; see below for more info.
⑫
Status LED; see below for more info.
⑬
Reset button; see below for more info.
Status LED
green
green, flashing
red
orange
orange, flashing
2)
1)
2)
3)
OK
software update in progress
error
head-end starting
head-end is being identified by the
USW 800 configuration software