Webasto SmarTemp Control 2.0 Instrucciones De Operación Y Instalación página 7

SmarTemp Control
 Time & Date
 Offset
 Default
Timer
Error Code
SW Version
Back
Definitions
Set time and date using the rotary knob and selection button.
12 (AM / PM) or 24 hour available.
The Webasto button can be used to go back to the previous
field if additional changes are needed.
Depending on the installation location, the temperature
reading may vary slightly. The Offset feature allows a
temperature adjustment of +/- 9°F (+/- 5°C). Adjust this as
necessary to obtain the most accurate ambient temperature
reading.
Default allows the user to perform a factory reset of the
control settings.
NOTE: Heater information will NOT be affected.
User can select a specific day, time and heater runtime up to 7
days in the future. Be aware this is a one occurrence timer
requiring the user to turn the timer "ON" again after each
scheduled timer use.
When selecting timer a sub-menu will appear (Edit, On, and
Off). To modify timer settings, select "edit". Select the day,
time, and heater runtime using the rotary knob and the
selection button. Settings are saved each time the selection
button is pressed. The heater runtime can be set to 30, 60,
90, or 120 minutes. If the timer function will be used regularly
for next day startups, the "ANY" setting can be used in place
of the day of the week. With this set, the timer will disregard
the day setting and start during the next 24-hour period
based on the time selected. The "ANY" setting is located in
the list of days between Saturday and Sunday.
This section will log the last 5 error codes and the date that it
was set. Highlight and select an error code for a full
description. If the heater produces an error code, the status
indicator lights will flash red and the error will display on the
main screen.
NOTE: Heater error codes cannot be reset through the
Webasto SmarTemp Control 2.0; a Webasto PC Diagnostics
tool is required. Refer to the heater service manual for
resetting an error code.
This displays the firmware version of the Webasto SmarTemp
Control 2.0.
Select this to return to the previous screen.
Installation - Operating Instructions
7
Default
12 hour
0°
N/A
Off
No Errors
Installed
Version
N/A