Porter Cable 444 Manual De Instrucciones página 14

ATTACHING OPTIONAL DUST WAND
NOTE: A wide variety of accessories, including a dust wand, is available for
this tool. Please refer to your Porter-Cable Catalog to determine if the dust
wand is supplied as standard equipment with your particular tool package.
The dust wand is available as an accessory, and may be used with any
Porter-Cable Model 444 Profile Sander.
The dust wand requires an external vacuum source (shop vac or dust
collection system). To attach dust wand to sander:
1. Insert dust wand pin (A) Fig. 13 into hole (B) Fig. 13.
2. Thread knob (C) Fig. 14 into tool, and tighten firmly.
3. Connect the dust wand to your vacuum source with a 1" vacuum hose.
Fig. 13
TO START AND STOP SANDER
The tool is equipped with a "rocker" type switch (A) Fig. 15 labeled "ON" and
"OFF".
1. Depress "OFF". Check to see that the power circuit voltage is the same
as that shown on the specification plate.
2. Connect Sander to power circuit.
3. While holding Sander firmly, and off the work surface, depress "ON".
4. When you are finished sanding, lift the tool off the work and depress
"OFF" to stop the tool.
Fig. 15
A
B
A
14
Fig. 14
Fig. 15A
C
B