DeLonghi EX 290HL Manual De Instrucciones página 11

DESCRIPTION OF THE REMOTE CONTROL
D1) ON/STAND-BY button
D2.1)Temperature decrease / programmed operation button
D2.2)Temperature increase / programmed operation button
D3) MODE function button
D4) Fan speed selection button
D5) Swing button (flap swing)
D6) Timer button
D3
D2.2
D6
TURNING THE APPLIANCE ON
• Plug into the outlet.
• Press the button (D1) (when turned on, the air con-
ditioner starts operating in the same mode as when it was
turned off) .
• To switch the appliance off, press button (D1)
remove the plug.
NOTE: Never switch the appliance off by removing the plug.
Always switch it off by pushing on the
few minutes before removing the plug. Only in this way the ap-
pliance will perform the standard checkings.
SELECTING THE OPERATING MODES
The commands available on the remote control correspond to
those on the appliance control panel (C).
Therefore, refer to the instructions in the previous chapters.
NOTE: The special functions D5-D6, are available from the re-
mote control only.
SWING BUTTON
The SWING button (D5) moves the grille flap, evenly distributing
the air into the room.
When the SWING button is pressed, the flap will begin to move
forwards and backwards alternatively.
If pressed again, the flap will be locked into its current position.
When the button is next pressed, the flap will start to move
forwards and backwards again.
NOTE: in order to avoid damaging the internal mechanisms, the
flap must not be moved manually.
SETTING THE TIMER
D1
D4
D2.1
D5
The timer allows for the delayed start up or shut down of the
appliance. This function will prevent wasting electricity by opti-
mising the operating periods.
How to program delayed start up
•
•
•
When the set time is elapsed, the appliance will start to operate
in the same operating mode that was previously set.
, then
Start up can be programmed at any time within the 24 hours
that follow. A few seconds after the timer is set, the setting is
acquired. The timer symbol stays lit and the display returns to
button and waiting
standby.
To cancel the timer program, touch the timer key (D6) twice.
The timer symbol (C10) will go off.
How to program delayed shut down
•
•
•
A few seconds after the timer is set, the setting is acquired, the
display shows the operating mode and the timer symbol stays
lit.
Once the set time is elapsed, the air conditioner goes into standby.
To cancel the timer program, touch the timer key (D6) twice.
The timer symbol (C10) will go off.
10
Plug in the appliance and set to standby.
Press the timer key (D6): the timer symbol (C10) and hours
(C6) light up.
Use the + (D2.2) or - (D2.1) key to set the number of hours
until the appliance should start up.
While the appliance is on in any operating mode, delayed
shut down can be programmed.
Press the timer key (D6): The timer symbol (C10) and hours
(C6) light up.
Use the + (D2.2) o - (D2.1) key to set the number of hours
until the appliance will shut down.