Static Electricity - UFESA AP8000 Manual De Instrucciones

●
During operation pay attention not to knock the
vacuum cleaner over or to spill water on the appliance.
●
During storage, the suction hose may be rolled up,
but not bent.
●
Do not expose the vacuum cleaner to atmospheric
conditions (rain, frost).
●
Do not use the vacuum cleaner without the foam
filter installed in the filter unit.
●
During operation, do not remove the tank lid and
do not take out the water filter unit from the tank.
●
Do not leave a switched on and operating vacuum
cleaner unattended.
●
The vacuum cleaner may only operate in a natural
position i.e. when it is placed with four wheels on
the surface.
SUGGESTION
Information on the product
and suggestions for its use
●
This appliance is intended for domestic use only.
●
Periodically clean the wheels. The dirt which
accumulates on the wheel axis may cause difficulties
in the wheel movement.
●
Move the vacuum cleaner carefully on doorsteps
and uneven surfaces, not to cause an excessive
rippling of the water inside the tank. This might
lead to a slight water overflow.
Appliance features
The AP8000 vacuum cleaner is intended to pick up
dirt from floors, carpets, ceramic tiles, slots in wood
paneling, skirting boards, heaters. The vacuum cleaner
is also used to vacuum furniture and curtains and to
pick up liquids.
Technical parameters
The type of the vacuum cleaner and the technical
parameters are indicated on the rating label. Mains
protection 16 A.
Does not interfere with radio and TV reception.
Noise level: 86 dB(A).

Static electricity

In the process of vacuuming of some surfaces in areas
of low air humidity the device may become electrically
charged. It is a natural phenomenon – it does not
damage the device, and it is not considered to be a fault.
In order to minimize the phenomenon, we recommend
you to:
● discharge the device by touching metal items in the
room with the pipe,
● increase air humidity in the room,
● use widely available antistatic agents.
Appliance elements
1
ON/OFF button
2 Handle
3
Plug and cord
4
Cord rewind button
5
Accessory compartment cover
6
Combination brush fastening
7
Motor filter (installed in the vacuum cleaner)
8 Foam filter II (installed in the vacuum cleaner)
9
EPA outlet filter (installed in the vacuum cleaner)
10
Foam filter III (installed in the vacuum cleaner)
11
Anti-foam agent
12
Inlet filter (installed in the vacuum cleaner)
13
Foam filter I (installed in the vacuum cleaner)
14
Suction hose
15 Telescopic suction tube
16
Crevice nozzle
17
Small brush
18
Small nozzle
19
Water pick up nozzle
20
Combination brush with a small item separator
21 Dry filtration module with SAFBAG dust bag
22
Water filter module (filtration unit + partition)
Preparing the vacuum cleaner for
operation
1
Install the appropriate module in the vacuum
cleaner (dry filtration module with the SAFBAG dust bag
or the water filter module) (see section
2
Insert and snap the tank lid shut.
3
Insert the end of the suction hose to the vacuum
cleaner opening so that the hose interlock is in the
protrusion of the opening. A characteristic click
indicates that the hose has been properly installed.
A
B
C E
and ).