Environmental Protection - Crown CT26010HX Manual Original

página de 180

/ 180
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

tion of milling� Do not push excessively - it takes some

time to complete the process� Excessive force will not

speed up the work process, but it will overload the

power tool�

• Turn the power tool off�

Guide with a roller (see fig. 11)

The guide 19 is used for milling edges with milling

cutters which do not have support bearings at the end�

Milling along the curved side surface is allowed (see

fig. 11.2).

• Install the guide 19 onto base plate 14 and adjust its

position as described above�

• Mill by pressing the roller 30 against the side surface

of the workpiece (see fig. 11.2).

Parallel guide (see fig. 12)

Parallel guide 18 enables milling along the straight line

side surface of the workpiece�

• Install the parallel guide 18 on the base plate 14,

and adjust its position as described above�

• Set the space from the work piece brim by adjusting

the parallel guide 18, as described above�

• Perform the milling operation by pressing parallel

guide 18 to the side surface of the workpiece (see fig. 12).

Power tool maintenance / preventive

measures

Before carrying out any works on the power tool

remove the battery 8.

Battery maintenance instruction

• Charge timely before the battery 8 is completely

exhausted� Stop operation in low power and charge

it immediately�

• Do not overcharge when the battery 8 is full, other-

wise it will shorten the life time�

• Charge battery 8 in the room temperature of 10°C

to 40°C (50°F to 104°F)�

• Charge battery 8 every 6 months without operation

for a long time�

• Replace worn out batteries in time� Decline of pro-

duction or a significantly shorter runtime of the power

tool after charging indicates aging of the battery 8 and

the need for replacement� It should be taken into ac-

count that the battery 8 may discharge faster if the

works take place in the temperature below 0°С.

• In case of long time storage without use, it is recom-

mended to store the battery 8 at room temperature, it

should be charged to 50%�

The manufacturer reserves the possibility to introduce changes.

Cleaning of the power tool

An indispensable condition for a safe long-term exploi-

tation of the power tool is to keep it clean� Regularly

flush the power tool with compressed air thought the

ventilation slots 2�

After-sales service and application service

Our after-sales service responds to your questions

concerning maintenance and repair of your product as

well as spare parts� Information about service centers,

parts diagrams and information about spare parts can

also be found under: www.crown-tools.com�

Transportation of the power tools

• Categorically not to drop any mechanical impact on

the packaging during transport�

• When unloading / loading is not allowed to use any

kind of technology that works on the principle of clamp-

ing packaging�

Li-Ion batteries

The contained Li-Ion batteries are subject to the Dan-

gerous Goods Legislation requirements� The user can

transport the batteries by road without further require-

ments�

When being transported by third parties (e�g�: air trans-

port or forwarding agency), special requirements on

packaging and labelling must be observed� For prepa-

ration of the item being shipped, consulting an expert

for hazardous material is required�

Dispatch batteries only when the housing is undam-

aged� Tape or mask off open contacts and pack up the

battery in such a manner that it cannot move around

in the packaging� Please also observe possibly more

detailed national regulations�