Basic Operation; Targeting Modes - Bushnell NITRO Guia Del Propietario

Battery Level Indicator Icon (2):
Full charge
3/4 battery level remaining
1/2 battery level remaining
1/4 battery level remaining
Battery icon blinks - battery needs to be replaced and unit will not be operable.

BASIC OPERATION

• While looking through the laser rangefinder, depress the Power/Fire button once to activate the display.
• If the display appears blurry, rotate the rubber eyecup/diopter adjustment in either direction until the display is sharp
for your vision.
• Placing the aiming circle (located in the center of the display) on a target at least 5-6 yards away, depress and hold the
Fire button down until the range reading is displayed below the aiming circle.
• Once a range has been acquired, you can release the Fire button. The four "crosshairs" just outside the aiming circle
will go out, indicating the laser is no longer being transmitted. The display will remain on and display the last distance
measurement for about 20-30 seconds, until the display automatically switches off to extend battery life.
• You can depress the Fire button again at any time to check the range to a new target. To re-fire, press the button down
again.
• To scan the laser across an area and get continuously updated range readings, simply continue to hold the Fire button
down and sweep the rangefinder over multiple targets. The crosshairs outside the aiming circle will flash to indicate scan
operation.
DISPLAY INDICATORS/ICONS
The Nitro rangefinder's display includes these elements:
Angle Range Compensation Modes
• Bow Mode (1)
Battery Level Indicator (2)
Aiming Circle/Dot (3)
Active/Scan Laser Indicator (4)

Targeting Modes

• Bullseye™ Mode (5)
• Brush™ Mode (6)
Primary Numeric Display displays Line-of-sight Distance (7)
Holdover / Bullet-drop Horizontal Distance indicators
for AbU/AbE Mode
• MOA holdover units selected (8)
• MIL (holdover units selected (9)
Range (Distance) Units (10): Y=Yards, M=Meters
Secondary Numeric Display
True Horizontal Distance in Bow mode (11), Elevation/Windage
Values (alternating 1.5 sec each) in AbU mode (12)
SETUP Mode (13)
Angle Indicator (each bar=approx. +/-5
Bluetooth Active (15)
TARGETING MODES
The Nitro laser rangefinder can be operated in one of three available targeting modes, with Standard mode as the default.
To select a different targeting mode, press the Mode button briefly until the desired indicator (BullsEye or Brush) appears.
To return to Standard mode, press Mode one more time after the Brush mode indicator is seen. The targeting modes are:
• Standard Mode with Automatic SCAN (LCD Indicator – none) This setting allows most targets to be ranged, up to 2,000
yards. Used for moderately reflective targets that are typical of most distancing situations. The minimum distance in the
standard mode is 5 yards. To use the Automatic SCAN feature, simply press and hold the Fire button, then move the
rangefinder from object to object while keeping the Fire button depressed. Automatic SCAN will allow the range to be
continuously updated as multiple objects are targeted. Crosshair lines flash while scanning.
• Bullseye Mode with Automatic SCAN (LCD Indicator (5) -
™
targets and game without inadvertently getting distances to background targets that have stronger signal strength.
incline) (14)
o
Elevation value in AbU mode
(u=Up, d=Down)
Example shows 2.5 Mils down
5
1
4
14
13
8
9
12
) This advanced mode allows easy acquisition of small
6
2
3
7
10
15
11
Windage value in AbU mode
(L=Left, R=Right)
Example shows 1.5 Mils left
3