Install The Battery - GE PNRQ20RBL Manual Del Usuario

Faucet Assembly (Cont.)
OPTIONAL ONE-PERSON FAUCET
TUBING INSTALLATION
1. From under the sink, gather the 1/4" drain line
(black), 3/8" drain line (black) and 3/8" outlet
tube (blue banded) in one hand with the drain
tubes the same length and the outlet tube offset
2. Wrap a rubber band around all 3 tubes.
3. Insert a typical No. 2 pencil through the rubber
band location.
4. Rotate the pencil down until it is in line with the
tubing and push up through the mounting hole.
Release the grip on the pencil and the tubes will
remain in position for easier faucet connection.
POWER CORD INSTALLATION
Connect power cord from
faucet to union outlet from
the Reverse Osmosis
Assembly.
NOTE: If extension cord
is required for a remote
location, this extension
connectors; typical 4 conductor will not work.
18
Installation Instructions

INSTALL THE BATTERY

1. Remove the lens cover from the faucet base.
Grip it from both sides and pull forward.
2. Install one CR2032 3V battery with the "+" side
UP into the battery tray. Slide the battery tray
completely back into the base.
Faucet base
Lens cover
3. The amber light will illuminate five times. If you
want to reinitiate the start-up sequence, remove
fully reset; then put the battery back in.
4.
the amber LED light will flash every 30 seconds
indicating it is time to replace the filter canister.
NOTE: The amber LED light may stop blinking
if it is allowed to blink for an extended period of
time. To ensure proper operation, the battery
should be replaced with every filter change.
FOR FILTER CHANGE: Replace the battery
when changing the filter. Remove the used
new battery to ensure the proper electronics are
WARNING
To reduce the risk associated
with choking, immediately dispose of the replaced
battery.
Battery "+"side up
49-50322