Installation
Instructions
Questions? Call 800.626.2005 or visit our Website at: GEAppliances.com/ge/service-and-
support/contact.htm
WARNING
Read entire manual. Failure to follow all guides and rules could cause
personal injury or property damage.
Check with your state and/or local public works department for plumbing codes. You must
follow their guides as you install the Water Filtration system.
NOTE: Failure to comply with these installation instructions will void the product warranty, and
the installer will be responsible for any service, repair or damages caused thereby.
TOOLS AND MATERIALS
REQUIRED FOR INSTALLATION
Electric drill and 1-1/2" Drill Bit (type as required) if
mounting is needed for faucet
Two (2) Adjustable Wrenches
Tape Measure
Phillips and Flat Blade Screwdrivers
Utility Knife
If your main water line is a rigid pipe, you will
require a compression fitting and possibly other
plumbing hardware to complete the installation.
IMPORTANT
sink, consult a qualified plumber or installer for
drilling procedures. Special drill bits may be needed
for stone, porcelain or stainless steel.
CONTENTS INCLUDED WITH
PRODUCT
Reverse Osmosis Assembly and Tubing
Product Literature (Owner's Manual and
Installation Instructions)
Performance Data Sheet
Feed Water Adapter
Faucet Assembly with Electronic Base Monitor
and Tubing
Storage Tank
Drain Line Adapter
Sanitation Canisters
10
Reverse Osmosis Filtration System
Models PNRQ20RBL, PNRQ21RBN, PNRQ21RRB
–
To avoid damaging the
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
–
IMPORTANT
for local inspector's use.
–
IMPORTANT
codes and ordinances.
Note to Installer – Be sure to leave these
instructions with the Consumer.
Note to Consumer – Keep these instructions for
future reference.
Proper installation is the responsibility of the
installer.
Product failure due to improper installation is not
covered under the Warranty.
A shutoff valve must be available or added near
the installation point.
Save these instructions
Observe all governing
49-50322