Weigh - OHAUS Adventurer SL Serie Manual De Instrucciones

Adventurer SL
3.3.1 Weigh Mode (Cont.)

Weigh

To access the Weigh mode, press and hold
Mode until the display shows WEIGH.
Press Zero to zero the balance.
Place objects to be weighed on the pan to display
the weight.
The example displays a 200 gram weight.
3.3.2 Count Mode
Use the Count mode to count parts of uniform
weight. Refer to Section. 3.5.3 to set the Count
mode ON. To access the Count mode, press
Mode until the display shows COUNT.
Establish an Average Piece Weight (APW).
Each time a new type of part is to be counted, the nominal weight of one piece
(Average Piece Weight) must be established using a small quantity of pieces. The
Average Piece Weight (APW) is stored in memory until replaced by a new APW.
If an APW has already been established, Clear
APW (CLR.APW) is displayed. Press No to use
the previously saved APW. Otherwise, press Yes
to establish a new APW.
The display indicates the number of pieces
to be used to establish the new APW.
If a different sample size is preferred, press No until the desired sample size is
displayed. Choices are Put 5, Put 10, Put 25, Put 50 or Put 100.
Put the specified number of pieces on the pan when the desired sample size is
displayed. To abort the APW, press and hold No. Otherwise press Yes to establish
and display the new APW.
This example shows 100 pieces on the pan
with an average weight per piece of 4.99 g.
Count
When the pieces indicator (PC) is displayed,
place the quantity to be counted on the pan.
The example shows 141 pieces.
EN-13