Tabla de contenido
Idiomas disponibles
Idiomas disponibles
NOTE: It may be necessary to move the handle
supports from side to side in order to align the handle
so it will slide over the handle supports.
4. Insert "L" bolt through hole on right side of handle
(viewing from handle side of unit) and attach
plastic knob. Tighten knob by hand.
5. Insert carriage bolt through left side hole from
outside of unit and attach a plastic knob from
inside of unit (viewing unit from the handle side).
Tighten by hand.
6. Insert "J" hook into second from left slot in
accessory tray.
7. Pinch chemical hose and slide it into metal clip as
shown.
8. Tilt unit up by handle and attach metal clip to rib
on center underside of accessory tray. Slide
chemical hose through metal clip so that it is tight
but not kinked.
Add Engine Oil
IMPORTANT: Any attempt to crank or start the engine
before it has been properly serviced with the
recommended oil may result in an engine failure.
NOTE: When adding oil to the engine crankcase, use
only high quality detergent oil rated with API service
classification SF, SG, SH, SJ or higher rated SAE 30
weight. DO NOT use special additives.
1. Choose a viscosity according to table below.
5W-30, 10W-30
Synthetic 5W-30, 10W-30
°F
-20
0
20
°C
-30
-20
-10
STARTING TEMPERATURE RANGE ANTICIPATED BEFORE NEXT OIL CHANGE
* The use of multi-viscosity oils (5W-30, 10W-30, etc.)
in temperatures above 40°F (4°C) will result in higher
than normal oil consumption. When using a multi-
viscosity oil, check oil more frequently.
** If using SAE 30 oil in temperatures below 40°F
(4°C), it will result in hard starting and possible
engine bore damage due to inadequate lubrication.
2. Place pressure washer on a level surface.
3. Clean area around oil fill.
4. Remove oil fill cap.
5. Pour oil slowly. Fill to the point of overflowing.
6. Replace oil fill cap, tighten securely.
NOTE: Check oil often during engine break–in.
Add Fuel
WARNING!
NEVER fill fuel tank indoors.
NEVER fill fuel tank when engine is running or
hot. Allow unit to cool for two minutes before
refueling. DO NOT light a cigarette or smoke
when filling the fuel tank.
WARNING!
NEVER fill fuel tank completely
full. Provide space for fuel expansion. Wipe
away any fuel spillage from engine and
equipment before starting.
•
Use fresh, clean unleaded automotive fuel and
store in approved, clean, covered containers. Use
clean fill funnels. NEVER use "stale" fuel left over
from last season or fuel stored for long periods.
•
Clean area around fuel fill cap, remove cap.
7
30
32
40
60
80
0
10
20
30
100
40
Capítulos
Tabla de contenido
