Denver Electronics CR-918 Instrucciones De Uso página 5

TO SET / RECALL THE RADIO PRESETS
1. Press the ON/OFF button (4) to turn the unit ON.
2. Use the Tune (5) or Tune (1) button to select the desired FM
station.
3. Press the SET - MEM/M+ button (2); "P02" will blink in the display.
4. Press the SET - MEM/M+ button (2) again to set the preset.
5. Repeat steps 2 through 4 to set more presets.
6. The unit can preset 10 stations totally for FM.
7. When "P01-P10" is blinking, press the Tune (5) or Tune (1)
button to select the preset number.
8. When recalling preset stations, press SET - MEM/M+ button (2) to
select the preset number.
RESETTING
If the system does not respond or exhibits erratic or intermittent
operation, you may have experienced an electrostatic discharge (ESD)
or a power surge that triggered the internal microcontroller to shut
down automatically. If this occurs, simply disconnect the ac power
cord and remove the system backup battery, wait for at least 3 minutes
and then setup the unit again as if it is a brand new unit.
SPECIFICATIONS
Radio frequency
Power supply
Battery backup
CAUTION
Danger of explosion if battery is incorrectly replaced. Replace only
with the same or equivalent type.
FM 87.5 – 108 MHz
AC230V ~ 50Hz, 5W
3V (CR2032 Flat Lithium battery x 1) not included.
ENG-4