Connecting Ac Power; Alarm Setting - Denver Electronics CR-918 Instrucciones De Uso

CONNECTING AC POWER

• Plug the AC power cord to a household outlet AC source.
Note: If an AC power failure occurs, the clock automatically switches
to the battery power supply, the clock and timer memory continue
running. When the AC power resumes, the clock switches back to AC
again.
TIME MANUAL SETTING
In standby mode, press and hold the SET - MEM/M+ button (2).
"24 Hr" will blink. Press the Tune (5) or Tune (1) button to set
the hour format between 12 hour (12 Hr) format and 24 Hour (24 Hr)
format.
Press the SET - MEM/M+ button (2) and the hours will blink.
Press the Tune (5) or Tune (1) to set the current hour.
Press the SET - MEM/M+ (2) button again then the minute digits will
blink. Press the Tune (5) or Tune (1) to set the current minutes.
Once setting done, press SET - MEM/M+ (2) button once again to
indicate the current time is set.

ALARM SETTING

1. Press the AL.1 / AL.2 button (6/7) once to preview the alarm time.
2. The alarm time is displayed and will blink, press & hold the AL.1 /
AL.2 button (6/7) for 3 seconds and the hours will blink.
3. Press the Tune (5) or Tune (1) to set the alarm hour.
4. Press the AL.1 / AL.2 button (6/7) again; the minute digits will blink.
Press the Tune (5) or Tune (1) to set the alarm minutes.
5. Press the AL.1 / AL.2 button (6/7) to set the alarm sound mode:
Buzzer or Radio.
6. The alarm sound mode will blink. Press Tune (5) or Tune (1)
to set the alarm sound mode.
7. If you select alarm sound mode with Radio, the volume will blink on
the display.
8. Press Tune (5) or Tune (1) to set the alarm radio maximum
volume. Then press the AL.1 / AL.2 button (6/7) when setting is
done.
Note: when the alarm rings, the volume of the alarm will gradually
increase.
ENG-2